Thank you for sharing your story. It is amazing the stories I have heard and the things you here the politicians debating over. The truth is out. They need to get over there guilty pride and pharmaceutical needs to be slapped down a few pegs. This is happening we just need to defend the corporations that back the oil, the pharma, any other corporation that doesn’t fight a health and balance model.

Ten trials have evaluated the efficacy of inhaled Cannabis in chemotherapy-induced N/V.[35-38] In two of the studies, inhaled Cannabis was made available only after dronabinol failure. In the first trial, no antiemetic effect was achieved with marijuana in patients receiving cyclophosphamide or doxorubicin,[35] but in the second trial, a statistically significant superior antiemetic effect of inhaled Cannabis versus placebo was found among patients receiving high-dose methotrexate.[36] The third trial was a randomized, double-blind, placebo-controlled, crossover trial involving 20 adults in which both inhaled marijuana and oral THC were evaluated. One-quarter of the patients reported a favorable antiemetic response to the cannabinoid therapies. This latter study was reported in abstract form in 1984. A full report, detailing the methods and outcomes apparently has not been published, which limits a thorough interpretation of the significance of these findings.[37]


Fig. 8. Scanning electron micrographs of the abaxial surface of a perigonal bract (which envelops the fruit). These bracts are the most intoxicating part of the plant, and may contain 20% THC, dry weight. The resin is synthesized both in stalked and sessile glands. Multicellular secretory glands (of phallic appearance), some broken stalks of these (note cellular appearance), and unicellular cystolith hairs (claw-like structures) are pictured. Fig. 9. Some important cannabinoids of cannabis resin. D9-THC (delta-9 tetrahydrocannabinol) is the chief intoxicant chemical and predominates in intoxicant strains, while the isomer D8-THC is usually present in no more than trace amounts. CBD (cannabidiol) is the chief non-intoxicant chemical, and predominates in non-intoxicant strains; it has sedative effects. The non-intoxicant CBN (cannabinol) is a frequent degradation or oxidation product. The non-intoxicant cannabichromene (CBC) is typically found in trace amounts in intoxicant strains. The non-intoxicant cannabigerol (CBG) is considered to be a precursor of the other cannbinoids (see Fig. 10).
Medical marijuana can soothe nausea and increase appetite, quiet pain, soothe anxiety and even reduce epileptic seizures. Other research on the healing effects of cannabis is being examined. For example, research suggests that THC may be able to improve memory according to a 2016 study on mice. More than half of the United States has legalized marijuana for medical use.

Hemp does best on a loose, well-aerated loam soil with high fertility and abundant organic matter. Well-drained clay soils can be used, but poorly-drained clay soils are very inappropriate because of their susceptibility to compaction, which is not tolerated. Young plants are sensitive to wet or flooded soils, so that hemp must have porous, friable, well-drained soils. Sandy soils will grow good hemp, provided that adequate irrigation and fertilization are provided, but doing so generally makes production uneconomical. Seedbed preparation requires considerable effort. Fall plowing is recommended, followed by careful preparation of a seedbed in the spring. The seedbed should be fine, level, and firm. Seed is best planted at 2–3 cm (twice as deep will be tolerated). Although the seedlings will germinate and survive at temperatures just above freezing, soil temperatures of 8°–10°C are preferable. Generally hemp should be planted after danger of hard freezes, and slightly before the planting date of maize. Good soil moisture is necessary for seed germination, and plenty of rainfall is needed for good growth, especially during the first 6 weeks. Seeding rate is specific to each variety, and this information should be sought from the supplier. Fiber strains are typically sown at a minimum rate of 250 seeds per m2 (approximately 45 kg/ha), and up to three times this density is sometimes recommended. In western Europe, seeding rates range from 60–70 kg/ha for fiber cultivars. Recommendations for seeding rates for grain production vary widely, from 10–45 kg/ha. Densities for seed production for tall, European, dual-purpose cultivars are less than for short oilseed cultivars. Low plant densities, as commonly found in growing tall European cultivars for seed, may not suppress weed growth adequately, and under these circumstances resort to herbicides may pose a problem for those wishing to grow hempseed organically. Hemp requires about the same fertility as a high-yielding crop of wheat. Industrial hemp grows well in areas that corn produces high yields. Growing hemp may require addition of up to 110 kg/ha of nitrogen, and 40–90 kg/ha of potash. Hemp particularly requires good nitrogen fertilization, more so for seed production than fiber. Adding nitrogen when it is not necessary is deleterious to fiber production, so that knowledge of the fertility of soils being used is very important. Organic matter is preferably over 3.5%, phosphorus should be medium to high (>40 ppm), potassium should be medium to high (>250 ppm), sulfur good (>5,000 ppm), and calcium not in excess (<6,000 ppm).
^ Jump up to: a b c This paper begins with a history of hemp use and then describes how hemp was constructed as a dangerous crop in the U.S. The paper then discusses the potential of hemp as an alternative crop. Luginbuhl, April M. (2001). "Industrial hemp (Cannabis sativa L): The geography of a controversial plant". The California Geographer (PDF). 41. California Geographical Society. pp. 1–14. Retrieved 2013-03-28. Hemp contains less than 1% THC, or tetrahydrocannabinols, the psychoactive property in marijuana. In other words, smoking hemp cannot create a 'high.' ... The dense growth of hemp eliminates other weeds.... The best growing technique for hemp, planting 300 to 500 plants per square meter, also helps authorities easily tell the hemp from marijuana, which is a plant that is less densely cultivated. (Roulac 1997; 149).

Did you get an answer for this? I have the exact same scenario. I'm treating my TN with Tegretol, and recently tried CBD. I think I took too much and there are some weird drug interactions with Tegretol and I felt quite stoned....was alone and talking to myself in my head thinking I was Einstein. It freaked me out a bit but I think I took too much. I'm trying lower doses again as recently my TN seems to be resisting the meds, although I have had a lot of emotional stress, which seems to be a trigger. Thanks!! Anna

Hemp

×