Cannabis has held sacred status in several religions. It has been used in an entheogenic context – a chemical substance used in a religious, shamanic, or spiritual context[59] - in the Indian subcontinent since the Vedic period dating back to approximately 1500 BCE, but perhaps as far back as 2000 BCE. There are several references in Greek mythology to a powerful drug that eliminated anguish and sorrow. Herodotus wrote about early ceremonial practices by the Scythians, thought to have occurred from the 5th to 2nd century BCE. In modern culture the spiritual use of cannabis has been spread by the disciples of the Rastafari movement who use cannabis as a sacrament and as an aid to meditation. The earliest known reports regarding the sacred status of cannabis in the Indian subcontinent come from the Atharva Veda estimated to have been written sometime around 2000–1400 BCE.[60]
Retting is generally done in the field (Fig. 46, 47). This typically requires weeks. The windrows should be turned once or twice. If not turned, the stems close to the ground will remain green while the top ones are retted and turn brown. When the stalks have become sufficiently retted requires experience—the fibers should have turned golden or grayish in color, and should separate easily from the interior wood. Baling can be done with any kind of baler (Fig. 48). Stalks should have less than 15% moisture when baled, and should be allowed to dry to about 10% in storage. Bales must be stored indoors. Retted stalks are loosely held together, and for highest quality fiber applications need to be decorticated, scutched, hackled, and combed to remove the remaining pieces of stalks, broken fibers, and extraneous material. The equipment for this is rare in North America, and consequently use of domestically-produced fiber for high quality textile applications is extremely limited. However, as described above relatively crude fiber preparations also have applications.
Cannabinoids are known to interact with the hepatic cytochrome P450 enzyme system.[3,4] In one study, 24 cancer patients were treated with intravenous irinotecan (600 mg, n = 12) or docetaxel (180 mg, n = 12), followed 3 weeks later by the same drugs concomitant with medicinal Cannabis taken in the form of an herbal tea for 15 consecutive days, starting 12 days before the second treatment.[4] The administration of Cannabis did not significantly influence exposure to and clearance of irinotecan or docetaxel, although the herbal tea route of administration may not reproduce the effects of inhalation or oral ingestion of fat-soluble cannabinoids.

Jump up ^ Hayakawa K, Mishima K, Nozako M, Ogata A, Hazekawa M, Liu AX, Fujioka M, Abe K, Hasebe N, Egashira N, Iwasaki K, Fujiwara M (March 2007). "Repeated treatment with cannabidiol but not Delta9-tetrahydrocannabinol has a neuroprotective effect without the development of tolerance". Neuropharmacology. 52 (4): 1079–87. doi:10.1016/j.neuropharm.2006.11.005. PMID 17320118.


Hi, Congrats on finishing chemo & radiation that’s awesome!! I wish you the best of luck!! I was actually wanting to know about dosage for cancer as well..My parents both have recently been diagnosed with cancer 4 months apart and are currently going thru chemo together. I have tried looking for the dosage info but can never find what i’m looking for..I want to try to help lesson the chemo side effects and hopefully kill some of the cancer cells. Can someone please help us?Thank You Christy
Henry Ford recognized the utility of hemp in early times. In advance of today’s automobile manufacturers, he constructed a car with certain components made of resin stiffened with hemp fiber (Fig. 19). Rather ironically in view of today’s parallel situation, Henry Ford’s hemp innovations in the 1920s occurred at a time of crisis for American farms, later to intensify with the depression. The need to produce new industrial markets for farm products led to a broad movement for scientific research in agriculture that came to be labeled “Farm Chemurgy,” that today is embodied in chemical applications of crop constituents.
The Gateway Hypothesis states that cannabis use increases the probability of trying "harder" drugs. The hypothesis has been hotly debated as it is regarded by some as the primary rationale for the United States prohibition on cannabis use.[249][250] A Pew Research Center poll found that political opposition to marijuana use was significantly associated with concerns about health effects and whether legalization would increase marijuana use by children.[251]

Hemp does best on a loose, well-aerated loam soil with high fertility and abundant organic matter. Well-drained clay soils can be used, but poorly-drained clay soils are very inappropriate because of their susceptibility to compaction, which is not tolerated. Young plants are sensitive to wet or flooded soils, so that hemp must have porous, friable, well-drained soils. Sandy soils will grow good hemp, provided that adequate irrigation and fertilization are provided, but doing so generally makes production uneconomical. Seedbed preparation requires considerable effort. Fall plowing is recommended, followed by careful preparation of a seedbed in the spring. The seedbed should be fine, level, and firm. Seed is best planted at 2–3 cm (twice as deep will be tolerated). Although the seedlings will germinate and survive at temperatures just above freezing, soil temperatures of 8°–10°C are preferable. Generally hemp should be planted after danger of hard freezes, and slightly before the planting date of maize. Good soil moisture is necessary for seed germination, and plenty of rainfall is needed for good growth, especially during the first 6 weeks. Seeding rate is specific to each variety, and this information should be sought from the supplier. Fiber strains are typically sown at a minimum rate of 250 seeds per m2 (approximately 45 kg/ha), and up to three times this density is sometimes recommended. In western Europe, seeding rates range from 60–70 kg/ha for fiber cultivars. Recommendations for seeding rates for grain production vary widely, from 10–45 kg/ha. Densities for seed production for tall, European, dual-purpose cultivars are less than for short oilseed cultivars. Low plant densities, as commonly found in growing tall European cultivars for seed, may not suppress weed growth adequately, and under these circumstances resort to herbicides may pose a problem for those wishing to grow hempseed organically. Hemp requires about the same fertility as a high-yielding crop of wheat. Industrial hemp grows well in areas that corn produces high yields. Growing hemp may require addition of up to 110 kg/ha of nitrogen, and 40–90 kg/ha of potash. Hemp particularly requires good nitrogen fertilization, more so for seed production than fiber. Adding nitrogen when it is not necessary is deleterious to fiber production, so that knowledge of the fertility of soils being used is very important. Organic matter is preferably over 3.5%, phosphorus should be medium to high (>40 ppm), potassium should be medium to high (>250 ppm), sulfur good (>5,000 ppm), and calcium not in excess (<6,000 ppm).
The public forum sessions provided an overview of the Alternative Crop Research Act, including the legal parameters set within the bill, and the procedures that will guide development of the rules and regulations. Guest speakers included Brent Burchett, the director of the plant division from the Kentucky Department of Agriculture, and Mitch Yergert, retired director of the division of plant industry from the Colorado State Department of Agriculture.

Pain management improves a patient’s quality of life throughout all stages of cancer. Through the study of cannabinoid receptors, endocannabinoids, and synthetic agonists and antagonists, the mechanisms of cannabinoid-induced analgesia have been analyzed.[46][Level of evidence:1iC] The CB1 receptor is found in the central nervous system (CNS) and in peripheral nerve terminals.[47] CB2 receptors are located mainly in peripheral tissue and are expressed in only low amounts in the CNS. Whereas only CB1 agonists exert analgesic activity in the CNS, both CB1 and CB2 agonists have analgesic activity in peripheral tissue.[48,49]

Best Hemp CBD Products

×